Hi guys, I got an incosistent pg and found it was due to a broken hdd. I marked this osd out and the cluster rebalanced without any problems. But the pg is still reported as incosistent. Before marking osd 2 out: HEALTH_ERR 1 pgs inconsistent; 1 scrub errors; noout flag(s) set pg 6.29f is active+clean+inconsistent, acting [8,2] 1 scrub errors noout flag(s) set After marking osd 2 out: HEALTH_ERR 1 pgs inconsistent; 1 scrub errors; noout flag(s) set pg 6.29f is active+clean+inconsistent, acting [8,10] 1 scrub errors noout flag(s) set I tried to run "ceph osd repair 6.29f" but the command seems to expect an osd-id rather than an pg-id when using emperor. So I did "ceph osd repair 8" and got a couple of 2013-12-28 14:50:05.301411 osd.8 [INF] XXX repair ok, 0 fixed messages, but the pg "6.29f" was not listed and is still marked as incosistent. How can I get the cluster stable again? :) Corin _______________________________________________ ceph-users mailing list ceph-users@xxxxxxxxxxxxxx http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
 |