Ceph -m 192.168.178.160:6789 -s Make sure your mon is running -----éäåä----- åää: ceph-devel-owner@xxxxxxxxxxxxxxx [mailto:ceph-devel-owner@xxxxxxxxxxxxxxx] äè Sage Weil åéæé: 2011å1æ20æ 13:05 æää: Gregory Farnum æé: Qian Wei; ceph-devel@xxxxxxxxxxxxxxx äé: Re: can't read the superbloack On Wed, 19 Jan 2011, Gregory Farnum wrote: > On Tue, Jan 18, 2011 at 6:38 PM, Qian Wei <hzqianwei@xxxxxxxxx> wrote: > > Now the my client machine still can't mount the system, the error > > message is "can't read the superblock ".Moreover, I can use > > "init-ceph" command to start the system,and the Â"cosd cmon cmds" is > > on process table(so I think the system is running), but I can't Âuse > > ?ceph? command to administrate the system, ?2011-01-13 13:27:05.800552 > > b5f41b70 -- :/4555 >> 192.168.178.160:0/0 pipe(0x8429c48 sd=3 pgs=0 > > cs=0 l=0).fault first fault ? is the error message.Do you know what's > > wrong may cause these problems? > Well, that "fault first fault" message is very generic so doesn't tell > us much. However, between that and the superblock error, there's > clearly some issue about communicating with your monitor. There are a > few ways to debug this, but let's check out your configuration file... > > [mon0] > >    Âhost = cephosd > >    Âmon addr = 192.168.178.160 > I'm pretty sure that's your problem. You need to specify a port as > well. If that doesn't resolve your issues, we can take a deeper look. Note that the default port is 6789.. you should use that: mon addr = 192.168.178.160:6789 sage ÿô.nlj·Ÿ®‰†+%ŠË±é¥Šwÿº{.nlj·œz˜ÿuëø¡Ü}©ž²ÆzÚj:+v‰¨þø®w¥þŠàÞ¨è&¢)ß«a¶Úÿûz¹ÞúŽŠÝjÿŠwèf
