Hello all,I'd like to connect to a CentOS 5.2 system's console through a null-modem cable. An USB to serial converter is connected to that system's USB port.
When using this configuration statement in "/etc/inittab"... ... # Run gettys on serial line (that is, a serial line connected to USB0) usb0:12345:respawn:/sbin/agetty -L ttyUSB0 9600 vt100 ......I get these messages if (and only if) the converter is *not* connected to the system (thus, if no ttyUSB0 device has been dynamically created):
Nov 18 15:58:41 anyvizor init: Id "usb0" respawning too fast: disabled for 5 minutes Nov 18 16:05:22 anyvizor init: Id "usb0" respawning too fast: disabled for 5 minutes Nov 18 16:12:03 anyvizor init: Id "usb0" respawning too fast: disabled for 5 minutes
Apart from that, connectivity to the serially attached console works fine of the serial line is connected.
Obviously, I would like to have a clean setup without any errors where this kind of console setup works like a charm.
As a workaround (since I did not get any further on an inittab-based solution), I tried to configure udev to spawn "/sbin/agetty -L ttyUSB0 9600 vt100" once the converter gets connected. This is my udev configuration:
[root@anyvizor rules.d]# pwd /etc/udev/rules.d [root@anyvizor rules.d]# cat 10-custom.rules BUS=="usb", KERNEL=="ttyUSB*" SYMLINK+="usb_attached_console"SUBSYSTEM=="usb_device", ACTION=="add", RUN+="/etc/udev/scripts/respawn_usb_attached_console.sh"
[root@anyvizor rules.d]# [root@anyvizor scripts]# pwd /etc/udev/scripts [root@anyvizor scripts]# cat respawn_usb_attached_console.sh #!/bin/env sh getty_command_line="/sbin/agetty -L usb_attached_console 9600 vt100"while [[ -e /dev/usb_attached_console && $(/usr/bin/pgrep -xf "${getty_command_line}" | /usr/bin/wc --lines) -eq 0 ]]
do
eval "${getty_command_line}"
done
[root@anyvizor scripts]#
Again, connectivity to the serially attached console works fine once the
system is up and running. However, the system does not pass the
Starting udev...message displayed on the console (here, I mean the normal console screen, not the serially attached console) if (and only if) the USB to serial converter is connected when booting. The boot process continues fine once the converter gets disconnected.
Any hints for an inittab-based as well as an udev-based solution (or another concept to achieve the same result) is very welcome!
Thanks, David
<<attachment: smime.p7s>>
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
