Jerry Geis wrote:
I have 2 questions dealing with 2 different kickstart files.
1) my kickstart sections for RAID disk setup and kickstart reports it
cannot find sda. Why is that. sda is there and works.
clearpart --all --initlabel
part raid.01 --asprimary --bytes-per-inode=4096 --fstype="raid"
--onpart=sda1 --size=20000
I've had issues with onpart in the past. I had to use ondisk and
trust the anaconda to put the partitions in a good place.
2) my kickstart section for normally single disk setup. However with 2
disks present in box
it put / on sda and /home on sdb. Is there a way to put it ALL on sda???
If there is a second disk I want it left alone.
clearpart --all --initlabel
part / --fstype ext3 --size=20000 --asprimary
part swap --size=4000 --asprimary
part /home --fstype ext3 --size=100 --grow --asprimary
Use --ondisk to specify which disk.
Also, if there is a 2nd disk, it will lose it's partition table because
of your clearpart. You may want ot explore an ignoredisk command.
--
Milton Calnek BSc, A/Slt(Ret.)
milton@xxxxxxxxxx
306-717-8737
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
