On Thu, 2008-02-28 at 20:31 +0000, Anne Wilson wrote: > On Thursday 28 February 2008 20:00:25 Ross S. W. Walker wrote: > > > > Here is a simple Vesa config that should work on most cards and monitors, > > I use it here at work during kickstart installs. > > > > Section "ServerLayout" > > Identifier "Default Layout" > > Screen 0 "Screen0" 0 0 > > InputDevice "Keyboard0" "CoreKeyboard" > > EndSection > > > > Section "InputDevice" > > Identifier "Keyboard0" > > Driver "kbd" > > Option "XkbModel" "pc105" > > Option "XkbLayout" "us" > > EndSection > > > > Section "Device" > > Identifier "Videocard0" > > Driver "vesa" > > EndSection > > > > Section "Screen" > > Identifier "Screen0" > > Device "Videocard0" > > DefaultDepth 24 > > SubSection "Display" > > Viewport 0 0 > > Depth 24 > > Modes "1280x1024" "1024x768" "800x600" "640x480" > > EndSubSection > > EndSection > > > Hi, Ross. Thanks for that. It got me in, but at a horrid 800x600, so I ran > system-config-display, setting it to generic 1280x1024, and leaving the vesa > driver. Then I got > > "out of range > H.Frequency: 75KHZ > V.Frequency: 60HZ" > > Back into vi, and set the refresh rates, and eureka! I'm back in business. > Is it worth trying the nv driver again, or should I leave well alone? > > Thanks for the help. That config is going to be printed out for > my "Emergencies" file. :-) ---- I was reluctant to state this because I have no authoritative knowledge on these things but if you change video cables, I think that you need to reboot to get the video chipset to properly recognize the cable/monitor connected. Craig _______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos