On Tue, 2007-09-11 at 13:19 +0000, gjgowey@xxxxxxxxxxxxxxxxxx wrote:Seems to me there is room to suspect a hardware issue instead of acpi. I would confirm power supply connector to mainboard by removing and reinserting until properly seated. Also would confirm two wires from power button on case/chassis are correctly connected to proper pin terminals at edge of mainboard. If still no joy, would swap a known good power supply. If that fails, you might try removing the power switch leads from the pin terminal strip and use a phillips screwdriver blade or other appropriate tool to short the proper pins momentarily to start the beast. I have replaced three bad power switches in the recent few years, so they do fail.
> I have one idea that may work. Try seeing if your bios supports a bios upgrade floppy (it would say so in the owners manual). Now by bios upgrade floppy I don't mean the usual type that use an os. There are some that the bios will directly read from without an os being used. The concept is to recover from failed bios upgrades. The reason I suggest this is because I think the setting that's keeping your system off is hiding in your bios' acpi table and I don't think a bios reset will dump it, but a bios upgrade might.
My motherboard do support such BIOS upgrades (really nice since it's OS
independent) but you need to get to the POST before you can ask it to
search for the floppy.
But it won't power on at all. The CPU FAN doesn't start, the disk
doesn't rotate, the monitor doesn't get any signal. The only thing that
indicates the slightest sign of life is the LED on the motherboard and
my keyboard if I press Num Lock.
Is there something on the motherboard I can disconnect to reset the ACPI
table?
Cheers,
B.J.
| CentOS 5.0, Linux 2.6.18-8.1.8.el5 x86_64 12:06:49 up 1 day, 6:14, 2 users, load average: 0.03, 0.05, 0.07 |
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
