Jeff Stacey wrote:
I have found for pxe installs that tftp would only work (for me) if the
owner:group of the files/directories in question are nobody:nogroup
Jeff
That is because tftp defaults to the user nobody, the server_args line I put in should have
taken care of that.
On Thu, 2006-12-28 at 14:05 -0600, Mark Snyder wrote:
chrism@xxxxxxxxx wrote:
Mark Snyder wrote:
tftp keeps timing out when I try to transfer files. I intend to
use
tftp with G4U to clone a standard workstation. I am testing it
between
two Dell poweredge servers running CentOS 4.3. "chkconfig --list
|grep tftp" shows tftp up and running on both boxes. When connected
"tftp>status" shows it is talking to the other box
"tptp>trace" shows "sent WRQ <file=slavelit, mode=netascii>" and
ends
with Transfer timed out.
I have tftp is being run under xinetd.
I have modified /etc/xinetd.d/tftpd as follows:
server_args -p -c -U 002 -u install -s /tster
I have setup a user install, set read/write privileges on /tster
which
is owned by install
Not sure what else I need to do to get this working, any
suggestions
would be appreciated
Have you checked the usual culprits? SELINUX or iptables? Try
disabling them one at a time and see if the bad behavior disappears.
both are disabled, but it was a good thought.
Cheers,
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
