Hi, all!
I want to change current RHEL 4.0 ES into CentOS 4.2 on Sun X4100 server.
The server has SAS SCSI based two 2.5" hard disks.
I could only install RHEL 4.0 Update 1 because the server is equipped with
RHEL 4.0 Update 1's device driver only.
I've included below the boot process messages concerned with SCSI controller.
If it's possible for me to install CentOS 4.0 on my X4100, I am ready to
switch to it.
TIA
Sungsoo Kim
-------------------
SCSI subsystem initialized
Fusion MPT base driver 3.02.18
Copyright (c) 1999-2005 LSI Logic Corporation
ACPI: PCI interrupt 0000:02:03.0[A] -> GSI 28 (level, low) -> IRQ 209
mptbase: Initiating ioc0 bringup
ioc0: SAS1064: Capabilities={Initiator}
Fusion MPT SCSI Host driver 3.02.18
scsi0 : ioc0: LSISAS1064, FwRev=01040000h, Ports=1, MaxQ=203, IRQ=209
Vendor: FUJITSU Model: MAV2073RCSUN72G Rev: 0301
Type: Direct-Access ANSI SCSI revision: 04
SCSI device sda: 143374738 512-byte hdwr sectors (73408 MB)
SCSI device sda: drive cache: write through
sda: sda1 sda2 sda3
Attached scsi disk sda at scsi0, channel 0, id 2, lun 0
Vendor: FUJITSU Model: MAV2073RCSUN72G Rev: 0301
Type: Direct-Access ANSI SCSI revision: 04
SCSI device sdb: 143374738 512-byte hdwr sectors (73408 MB)
SCSI device sdb: drive cache: write through
sdb: sdb1
Attached scsi disk sdb at scsi0, channel 0, id 3, lun 0
