That's the thing Mark, configuring it is where I'm stuck. I'm unsure of
what addresses I'm supposed to be using as the prefixes that Hurricane
Electric gives me for /64 and /48, are different from the tunnel's endpoint
address. At least I think I'm reading it right from the tunnel's
information page.
So when I use those to configure dhcpd6.conf and try to run (the second)
dhcpd, it tells me it hasn't been configure to use any interface. Even
though I'm telling it to on the command line I'm using to test the
configuration. Regardless of what interface I tell it to use, it fails.
So I was hoping someone has a working config that works with HE's setup.
On Oct 1, 2014 9:24 AM, "Mark Tinberg" <mark.tinberg@xxxxxxxx> wrote:
> > All of my servers and
> > workstations are able to ping6 to outside targets, and anything with a
> browser
> > installed can open ipv6.google.com.
> >
> > So far I have figured out that you have to run TWO instances of DHCP.
> One
> > instance issues IPv4 and the other issues IPv6. I have not gone so
> far as
> > to actually set up a second instance of DHCP.
>
> As long as you run a router advertisement daemon clients will self-assign
> routable addresses, you don't really need DHCPv6 if you are also running
> DHCPv4, you can set DNS (even an IPv6 DNS server) or any other
> configuration using the DHCPv4 daemon.
>
> —
> Mark Tinberg
> mark.tinberg@xxxxxxxx
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
>
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
