HP ML110 G6: how to update kernel with HP hpahcisr raid driver installed

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]



Hi!

I have install Centos 5.5 on HP ProLiant ML110 G6
with RAID-1 hardware active.

(00:1f.2 RAID bus controller: Intel Corporation 5 Series/3400 Series Chipset SATA RAID Controller (rev 05))

I have follow this suggest:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=3984625&prodNameId=3984626&swEnvOID=4006&swLang=13&mode=2&taskId=135&swItem=MTX-d7a175cef91649e7ab86653b61

... start with "linux dd" and, at the end of setup, 
install the hpahcisr into kernel 2.6.18-194.el5PAE

But after reboot if I run a "yum update" and reboot, the new kernel not
contain the driver hpahcisr for new kernel and I get a kernel panic. 

The question is:

How to update to last kernel without lost the proprietary driver?

It's possible?

Where is the new driver for new kernel?

Many thanks.

-- 
Dario Lesca <d.lesca@xxxxxxxxxx>

_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos


[Index of Archives]     [CentOS]     [CentOS Announce]     [CentOS Development]     [CentOS ARM Devel]     [CentOS Docs]     [CentOS Virtualization]     [Carrier Grade Linux]     [Linux Media]     [Asterisk]     [DCCP]     [Netdev]     [Xorg]     [Linux USB]
  Powered by Linux