-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Greetings folks,
I'm currently redoing my home server as one of the hard drives in my
RAID-1 array went down and I'm going to replace the lot of it with a
3Ware Escalade 9500S RAID capable card and four Seagate 200GB SATA
drives. These drives are supposedly the coolest and quietest SATA
drives available (better than the Maxtors I had anyway) and the capacity
upgrade on the server is worth the $$$ at this point. I'm planning on
running them in RAID-5 for maximum disk space and performance.
Are there any 3Ware Escalade/SATA issues I should be aware of when
building this new server utilizing CentOS-3? The card was supposedly
supported under RH9, so I figured RHEL3 (or clones) would be fine.
Thanks in advance for the feedback,
- --Shawn
- --
- -- Shawn M. Jones
<smj@xxxxxxxxxxxxxxxxxx>
http://www.littleprojects.org
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)
iD8DBQFBP9K3gaOAAb5cjIkRArVLAJ90/xrq4j8qsu8oAj6vaJlBS5pUAQCggH3a
fUKM52EQlz/BzR9q5dLKrvQ=
=RfLF
-----END PGP SIGNATURE-----
