|
Greetings, I’m new to xen virtualization on CentOS, but I have
been unable to find the answer to this problem I’m experiencing. My setup: AMD quad core (64bit), 8Gb ram. CentOS 5.3 dom0,
CentOS 5.3 domU’s (paravirtualized). Dom0 is set up with two NIC’s, the built-in and a PCI
card, and I set up xen bridging on both interfaces. My domU’s seem to boot up fine, run fine, and shutdown
fine. However, if I attempt a reboot operation, they go into a state where
they continually crash on startup. I have been unable to ascertain why this
happens, and I do not know how to fix it when it does happen. So, my question
is twofold: 1)
How do I get it out of the continual boot/crash cycle?
Xm destroy doesn’t work, none of the GUI tools work. So far the only
answer has been rebooting dom0, which is not a good answer L 2)
Has anyone else seen this/solved this? Besides being
able to manually fix it from #1 above, it sure would be nice to have it able to
reboot as expected. I haven’t worked with any fully virtualized guests
yet, but I will try that pretty soon and see if it evidences the same
behavior. Uname –a è Linux
prathis.localdomain 2.6.18-128.7.1.el5xen #1 SMP Mon Aug 24 09:14:33 EDT 2009
x86_64 x86_64 x86_64 GNU/Linux Please let me know what additional information would be
helpful or what I can do to facilitate debugging this issue.
|
_______________________________________________ CentOS-virt mailing list CentOS-virt@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos-virt
