Use 32-bit subranges to prune some 64-bit BPF_JEQ/BPF_JNE conditions that otherwise would be "inconclusive" (i.e., is_branch_taken() would return -1). This can happen, for example, when registers are initialized as 64-bit u64/s64, then compared for inequality as 32-bit subregisters, and then followed by 64-bit equality/inequality check. That 32-bit inequality can establish some pattern for lower 32 bits of a register (e.g., s< 0 condition determines whether the bit #31 is zero or not), while overall 64-bit value could be anything (according to a value range representation). This is not a fancy quirky special case, but actually a handling that's necessary to prevent correctness issue with BPF verifier's range tracking: set_range_min_max() assumes that register ranges are non-overlapping, and if that condition is not guaranteed by is_branch_taken() we can end up with invalid ranges, where min > max. [0] https://lore.kernel.org/bpf/CACkBjsY2q1_fUohD7hRmKGqv1MV=eP2f6XK8kjkYNw7BaiF8iQ@xxxxxxxxxxxxxx/ Signed-off-by: Andrii Nakryiko <andrii@xxxxxxxxxx> --- kernel/bpf/verifier.c | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+) diff --git a/kernel/bpf/verifier.c b/kernel/bpf/verifier.c index 2627461164ed..8691cacd3ad3 100644 --- a/kernel/bpf/verifier.c +++ b/kernel/bpf/verifier.c @@ -14214,6 +14214,18 @@ static int is_scalar_branch_taken(struct bpf_reg_state *reg1, struct bpf_reg_sta return 0; if (smin1 > smax2 || smax1 < smin2) return 0; + if (!is_jmp32) { + /* if 64-bit ranges are inconclusive, see if we can + * utilize 32-bit subrange knowledge to eliminate + * branches that can't be taken a priori + */ + if (reg1->u32_min_value > reg2->u32_max_value || + reg1->u32_max_value < reg2->u32_min_value) + return 0; + if (reg1->s32_min_value > reg2->s32_max_value || + reg1->s32_max_value < reg2->s32_min_value) + return 0; + } break; case BPF_JNE: /* constants, umin/umax and smin/smax checks would be @@ -14226,6 +14238,18 @@ static int is_scalar_branch_taken(struct bpf_reg_state *reg1, struct bpf_reg_sta return 1; if (smin1 > smax2 || smax1 < smin2) return 1; + if (!is_jmp32) { + /* if 64-bit ranges are inconclusive, see if we can + * utilize 32-bit subrange knowledge to eliminate + * branches that can't be taken a priori + */ + if (reg1->u32_min_value > reg2->u32_max_value || + reg1->u32_max_value < reg2->u32_min_value) + return 1; + if (reg1->s32_min_value > reg2->s32_max_value || + reg1->s32_max_value < reg2->s32_min_value) + return 1; + } break; case BPF_JSET: if (!is_reg_const(reg2, is_jmp32)) { -- 2.34.1
