Hello Martin > David Stockwell wrote: >> While attempting to test SSP with 3.34-3.35, I found that I was >> unable >> to pair with SSP; I was able to pair with the legacy >> pin-request/response mode. I checked the HCI level of my aging BT >> dongle (somehow this sounds a bit "dirty"), and found that it was >> only >> HCI 1.1 compliant. Replacing it with a BT2.0+EDR compliant dongle, I >> found that it still would not pair with SSP. >> >> Consulting with CSR, they confirmed that unless both devices are >> Bluetooth HCI 2.1 compliant, SSP will not work; it will always fall >> back >> to Legacy pairing. >> >> I searched yesterday for HCI 2.1-compliant dongles, and found only >> one, >> from Logitec (not Logitech) in Japan. These are not available in the >> US >> market. >> > > you can update CSRs BT2.0 with 2.1 Firmware. That should work. I think > you can download the firmware on the csr support site. > I will give this a shot. Thanks. Will also need to see if my even newer dongle can be upgraded. DS > > ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Bluez-devel mailing list Bluez-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.sourceforge.net/lists/listinfo/bluez-devel
