Hi Everyone, I recently found this list, and have enjoyed reading the various topics so far. I have a Raspberry Pi 4 with 8 GB of RAM, that I would like to get up and running with Orca and the Mate Desktop. I followed this excellent guide from: Getting the orca screen reader working on a raspberry pi 4 with Raspbian buster and the mate desktop (techesoterica.com) <https://techesoterica.com/getting-the-orca-screen-reader-working-on-a-raspb erry-pi-4-with-raspbian-buster-and-the-mate-desktop/> Everything seems to go well, until I reboot at the final step. Instead of receiving the message: "Screen Reader On", I am presented with the message: "To install the screen reader, press ctrl+alt+space." I have done this, (both left and right ctrl+alt combinations), but that doesn't seem to be what the Pi will accept. I am using a standard USB QWERTY keyboard. I have tried left super+alt+S, and alt+F2, then Orca, to no avail. I had a previous image of Buster that I did this on, with the same results, so I ran around raspi-config, thinking I needed to change the locale or keyboard layout. I got into the weeds there, so re-wrote the image onto the SD card, and started anew. Any direction you all can give, would be most appreciated. I am, at this point, stuck with the message on a 15-second loop, and installation cannot proceed. Thanks, Rachel. _______________________________________________ Blinux-list mailing list Blinux-list@xxxxxxxxxx https://listman.redhat.com/mailman/listinfo/blinux-list