According to Brian Tew: # What command lineprogram can I use to configure linux for a cable modem? How is the cable modem connected to the computer? Most of the time, the network should just come up automatically, as most distros try to get an IP address from either the cable modem or a router that you may have connected using DHCP, which just queries a server to get an assigned IP address. If this doesn't work immediately, try powercycling the modem, usually by unplugging it for about 15 to 20 seconds and plugging the power cable back in. Many times, if you transferred the modem from one device to another, even if it's between a computer and a router, it requires a reboot of the modem to reset it to assign an address to the new device. Powercycling will solve that problem so that it once again works properly. If you still can't get an address and connectivity to the internet, you may need to explicitly enable networking. This can be distro specific, but is usually done by executing one of the following: sudo service dhcpcd start sudo systemctl start dhcpcd sudo /etc/init.d/dhcpcd start or something similar. This is the most basic networking setup that will get a computer connected via wired ethernet connection to either a router or a cable modem. For more advanced networking, you may want to have a look at network-manager or another package that has advanced command line and graphical tools for configuring wired and wireless networks. Hope this helps. ~Kyle http://kyle.tk/ -- "Kyle? ... She calls her cake, Kyle?" Out of This World, season 2 episode 21 - "The Amazing Evie" _______________________________________________ Blinux-list mailing list Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list