I do not seem to be able to get Brailletty to start. I get an unable to open device or read device such and such followed by unable to read screen. I typed brltty serial:ttyS0 and even tried just brltty but still get the same error messages. On Mon, 2007-07-02 at 14:06 -0400, Dave Mielke wrote: > [quoted lines by michaelweaver on 2007/07/02 at 18:33 +0100] > > >Does the Braillenote need to be connected to the PC during a Linux > >installation before it can be used? > > I don't understand your question. If you want to use it during an install then, > of course, it must be connected during that install. If you just want to use it > later then you just need to connect it later. The application which makes it > work as a braille display is brltty, so you really only need it connected while > brltty is running. > > >Also will I need to select any keywords or serial port for the > >Braillenote? > > You'll need to tell brltty which serial port your BrailleNote is connected to. > You can do this via brltty's -d option or via its braille-device configuration > file directive. Specify something like: serial:ttyS0 > _______________________________________________ Blinux-list mailing list Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list