does speak up support echo synth? ----- Original Message ----- From: "Ari Moisio" <armoi@xxxxxx> To: "Linux for blind general discussion" <blinux-list@xxxxxxxxxx> Sent: Sunday, July 25, 2004 11:45 PM Subject: Re: Slackware 10 dropped serial console support > Hi! > > Thanks for the suggestion. Unfortunately Speakup does not help, i have no > supported synt. > > btw: any volunteer to write 'dummy' synth driver witch only send > characters to serial port and does not use any handshake or controls? This > would allow to use any talking serial terminal as barebone synth during > install or rescue boot. > > > -- > arimo > > On Sun, 25 Jul 2004, Jude DaShiell wrote: > > > I never booted slackware that way. What I did do was put a > > serial=0,9600,n8 statement in global section of lilo.conf and also moved > > that speakup line down into the linux boot section then saved lilo.conf, > > and then ran lilo before rebooting. That's always worked for me and I > > have it working in slackware 10.0. > > > > > > > > On Sun, 25 Jul 2004, Ari Moisio wrote: > > > > > HI! > > > > > > Has anybody other noticed this: when booting slackware 10 with bare.i or > > > speakup.s console=ttyS... -parameter does not anymore have any effect. > > > > > > With older SW 9.1 it worked ok. > > > > > > > > > -- > > > arimo > > > > > > > > > _______________________________________________ > > > > > > Blinux-list@xxxxxxxxxx > > > https://www.redhat.com/mailman/listinfo/blinux-list > > > > > > > > _______________________________________________ > > Blinux-list@xxxxxxxxxx > https://www.redhat.com/mailman/listinfo/blinux-list _______________________________________________ Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list