Hi! Thanks for the suggestion. Unfortunately Speakup does not help, i have no supported synt. btw: any volunteer to write 'dummy' synth driver witch only send characters to serial port and does not use any handshake or controls? This would allow to use any talking serial terminal as barebone synth during install or rescue boot. -- arimo On Sun, 25 Jul 2004, Jude DaShiell wrote: > I never booted slackware that way. What I did do was put a > serial=0,9600,n8 statement in global section of lilo.conf and also moved > that speakup line down into the linux boot section then saved lilo.conf, > and then ran lilo before rebooting. That's always worked for me and I > have it working in slackware 10.0. > > > > On Sun, 25 Jul 2004, Ari Moisio wrote: > > > HI! > > > > Has anybody other noticed this: when booting slackware 10 with bare.i or > > speakup.s console=ttyS... -parameter does not anymore have any effect. > > > > With older SW 9.1 it worked ok. > > > > > > -- > > arimo > > > > > > _______________________________________________ > > > > Blinux-list@xxxxxxxxxx > > https://www.redhat.com/mailman/listinfo/blinux-list > > > _______________________________________________ Blinux-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/blinux-list