On Tue, 27 Sep 2022, Ed R via lists.automotivelinux.org wrote: > Hi, > > I am new to this group and noticed an issue while interfacing official Raspberry PI 4 touch screen with Raspberry PI 4 board and latest Needlefish 14.0.1 release. After much search I found out that it worked with icefish and tried > that release on my setup, which works perfectly fine. > > I am downloading Needlefish 14.0.1 release image. This works perfectly fine with HDMI display. But with touch screen, U-boot comes up and initial boot messages are displayed on the screen, once Linux boots up no display. I have > serial console connected, system is up and I can access the Linux console. > > dtoverlay=vc4-kms-dsi-7inch > > Also, I can bring up the display by appending “ dtoverlay=vc4-kms-dsi-7inch > > “ to /boot/config.txt but the screen resolution is incorrect. Mode changes to screen resolution or name changes to DSI in weston.ini makes no difference. > > I’m sure I am missing some documentation which changed between icefish and later releases. > > Any help is greatly appreciated! We stopped supporting scaling of the UI in the demo at some point, so what you're seeing is expected since the touchscreen isn't 1920x1080. Scott -=-=-=-=-=-=-=-=-=-=-=- Links: You receive all messages sent to this group. View/Reply Online (#10166): https://lists.automotivelinux.org/g/agl-dev-community/message/10166 Mute This Topic: https://lists.automotivelinux.org/mt/93950260/2167316 Group Owner: agl-dev-community+owner@xxxxxxxxxxxxxxxxxxxxxxxxx Unsubscribe: https://lists.automotivelinux.org/g/agl-dev-community/leave/4543822/2167316/883735764/xyzzy [list-automotive-discussions82@xxxxxxxxxxx] -=-=-=-=-=-=-=-=-=-=-=-