There is an article in AGL wiki about connman that might help:
https://wiki.automotivelinux.org/connman
Regards,
Leon
On 8.04.20 г. 15:29 ч., Jan Simon
Moeller wrote:
Hi!
AGL uses connman.
Check the settings ui . There is a section about wired Network.
In the terminal you can use connman_ncurses.
Best,Js
<leonid.lazarev@xxxxxxxx> schrieb am Mi., 8. Apr. 2020, 14:25:
Hello,
I am working on raspberrypi 4 configuration and have one question.
How AGL configures the eth0 device? What configs/scripts are used to bring up eth0 and request IP address over DHCP?
As I got the systemd-netwotkd.service is used to manage network on AGL (Am I correct?), but I do not see the configuration for eth0 device in /lib/systemd/network.
From system loading I see only that eth0 is up:
[ 13.830234] bcmgenet fd580000.genet eth0: Link is Up - 100Mbps/Full - flow control rx/tx[ 13.838080] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
Configuration:
- PPI4,
- icefish (February 2020 build)
- eth cable(with DHCP enabled),
Best Regards
Leonid Lazarev
-- Leon Anavi Software Engineer konsulko.com
_._,_._,_
Links:
You receive all messages sent to this group.
View/Reply Online (#8214) |
Reply To Group
| Reply To Sender
|
Mute This Topic
| New Topic
Mute #help
Your Subscription |
Contact Group Owner |
Unsubscribe
[list-automotive-discussions82@xxxxxxxxxxx]
_._,_._,_
