Hi: I have an asus board with the 3112 controller and I could not get it to work properly in "semi-hardware" raid onfiguration either with RD8 or RD9. I did not spend alot of time with it. I can alo see the drives seperate even though the bios is configured as raid. Please let me know if you get this to work, altough I am probably going to install an LSI SCSI raid board with SCSI drives. Thanks ort11@xxxxxxxxxx -----Original Message----- From: ataraid-list-request@xxxxxxxxxx [SMTP:ataraid-list-request@xxxxxxxxxx] Sent: Thursday, June 26, 2003 11:00 AM To: ataraid-list@xxxxxxxxxx Subject: Ataraid-list digest, Vol 1 #485 - 1 msg Send submissions to ataraid-list@xxxxxxxxxx To subscribe or unsubscribe via the World Wide Web, visit https://www.redhat.com/mailman/listinfo/ataraid-list or, via email, send a message with subject or body 'help' to ataraid-list-request@xxxxxxxxxx You can reach the person managing the list at ataraid-list-admin@xxxxxxxxxx When replying, please edit your Subject line so it is more specific than "Re: Contents of Ataraid-list digest..." Today's Topics: 1. silraid init: no array found Why? (Robert Hardy) --__--__-- Message: 1 Date: Thu, 26 Jun 2003 04:31:55 -0400 (EDT) From: Robert Hardy <rhardy@xxxxxxxxx> To: ataraid-list@xxxxxxxxxx Subject: silraid init: no array found Why? Reply-To: ataraid-list@xxxxxxxxxx I have a Abit IC7-G with a SI3112 SATA Raid controller on it. I'm trying to get the silraid driver to recognize my array (A pair of Maxtor SATA 80G) which I setup in the bios and have test installed Windoze onto. I tossed silraid.o and ataraid.o from the RedHat 9 dist onto a floppy and tried to load them once I got booted up using RedHat 9 rescue setup. While my 3112 controller is recognized during bootup and I can access the two underlying drives as hdc and hde I cannot get the silraid driver to load. When I insmod ataraid and then insmod silraid I get this output: "driver for Silicon Image(tm) Medley(tm) hardware version 0.0.1: No raid array found" That shows up around line 455 in the source code but that doesn't really help. What am I doing wrong here? I ran for years on my old pdc20276 so I have some experience with ataraid. I actually recall a simlar problem back at install time there too but I've forgotten now... Regards, Rob -- ---------------------"Happiness is understanding."---------------------- Robert Hardy, B.Eng Computer Systems C.E.O. Webcon Inc. rhardy <at> webcon <dot> ca GPG Key available (613) 276-7327 --__--__-- _______________________________________________ Ataraid-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/ataraid-list End of Ataraid-list Digest
