2.4.18 stock was giving me huge problems on my Fasttrak TX4. Upgrading to 2.4.19-pre7 changed the Promise chip ID message from 20268 to 20270, and completely solved all issues I was having. No long startup delays, no lost interrupt, just pure multi-OS RAID bliss. - Forge On Saturday 27 April 2002 08:20 am, you wrote: > I had the same problem. > I simply had to change the PCI-Slot for the HPT370 Controller card.. > Now everything works perfect > > > -----Ursprüngliche Nachricht----- > Von: ataraid-list-admin@xxxxxxxxxx > [mailto:ataraid-list-admin@xxxxxxxxxx] Im Auftrag von Lau Bech Lauritzen > Gesendet: Samstag, 27. April 2002 03:01 > An: ataraid-list@xxxxxxxxxx > Betreff: Lost Interrupt, agian (on HPT370) > > Hey > I really need help. > I've been all over the internet looking for at solution to my problem. > I've also seen a lot of people with the same problem, but nothing has > helped yet. > > My problem is that i get a large amount of "hgx: lost interrupt" at > start up on the disks on my HPT370 controller. > > Here's a little info: > I'm running Debian with 2.4.19 pre6 kernel > Tryed BIOS version 2.2 and 2.31 > Tryed 2x60GB IBM 60GXP > Tryed 2x60GB Mator > Using High Points own 1.3 driver (hpt37x2.o) > hpt37x2.o is in /lib/modules/2.4.19-pre6/ > The module has also been added to /etc/modules > > [/] lsmod > Module Size Used by Tainted: P > NVdriver 941728 10 (autoclean) > hpt37x2 57248 0 > > Everything works fine (the array has been parted), but mig boot time is > about 5 min. and that's quite a draw back! > > Please help... > > -Lau > > PS: here's the dmesg > > VP_IDE: IDE controller on PCI bus 00 dev 21 > VP_IDE: detected chipset, but driver not compiled in! > VP_IDE: chipset revision 16 > VP_IDE: not 100% native mode: will probe irqs later > ide1: BM-DMA at 0xd800-0xd807, BIOS settings: hdc:DMA, hdd:DMA > ide2: BM-DMA at 0xd808-0xd80f, BIOS settings: hde:pio, hdf:pio > HPT372: IDE controller on PCI bus 00 dev 50 > HPT372: detected chipset, but driver not compiled in! > PCI: Found IRQ 9 for device 00:0a.0 > HPT372: chipset revision 5 > HPT372: not 100% native mode: will probe irqs later > ide3: BM-DMA at 0x9000-0x9007, BIOS settings: hdg:pio, hdh:pio > ide4: BM-DMA at 0x9008-0x900f, BIOS settings: hdi:pio, hdj:pio > PDC20265: IDE controller on PCI bus 00 dev 88 > PCI: Found IRQ 10 for device 00:11.0 > PCI: Sharing IRQ 10 with 00:0b.0 > PDC20265: chipset revision 2 > PDC20265: not 100% native mode: will probe irqs later > PDC20265: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode. > ide0: BM-DMA at 0x6400-0x6407, BIOS settings: hda:pio, hdb:pio > ide5: BM-DMA at 0x6408-0x640f, BIOS settings: hdk:pio, hdl:DMA > hda: IC35L060AVER07-0, ATA DISK drive > hdc: ASUS CD-S400/A, ATAPI CD/DVD-ROM drive > hdd: PLEXTOR CD-R PX-W1210A, ATAPI CD/DVD-ROM drive > hdg: MAXTOR 6L060J3, ATA DISK drive > hdi: MAXTOR 6L060J3, ATA DISK drive > hdk: IC35L040AVER07-0, ATA DISK drive > hdl: IC35L040AVER07-0, ATA DISK drive > ide0 at 0x7800-0x7807,0x7402 on irq 10 > ide1 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide3 at 0xa400-0xa407,0xa002 on irq 9 > ide4 at 0x9800-0x9807,0x9402 on irq 9 > ide5 at 0x7000-0x7007,0x6802 on irq 10 > hda: 120103200 sectors (61493 MB) w/1916KiB Cache, CHS=119150/16/63, > UDMA(100) > hdg: lost interrupt > hdg: lost interrupt > hdg: lost interrupt > hdg: 117266688 sectors (60041 MB) w/1819KiB Cache, CHS=116336/16/63 > hdg: lost interrupt > hdg: lost interrupt > hdi: lost interrupt > hdi: lost interrupt > hdi: lost interrupt > hdi: 117266688 sectors (60041 MB) w/1819KiB Cache, CHS=116336/16/63 > hdi: lost interrupt > hdi: lost interrupt > hdk: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, > UDMA(100) > hdl: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, > UDMA(100) > hdc: ATAPI 40X CD-ROM drive, 128kB Cache > Uniform CD-ROM driver Revision: 3.12 > Partition check: > hda: [PTBL] [7476/255/63] hda1 hda2 hda3 hda4 < hda5 > > hdg:hdg: lost interrupt > [PTBL] [7299/255/63] hdg1 hdg2 hdg3 <hdg: lost interrupt > > hdi:hdi: lost interrupt > unknown partition table > hdk: [PTBL] [5005/255/63] hdk1 < hdk5 > > hdl: [PTBL] [5005/255/63] hdl1 < hdl5 > > > > > > _______________________________________________ > > Ataraid-list@xxxxxxxxxx > https://listman.redhat.com/mailman/listinfo/ataraid-list > > > > > > _______________________________________________ > > Ataraid-list@xxxxxxxxxx > https://listman.redhat.com/mailman/listinfo/ataraid-list
