I had the same problem. I simply had to change the PCI-Slot for the HPT370 Controller card.. Now everything works perfect -----Ursprüngliche Nachricht----- Von: ataraid-list-admin@xxxxxxxxxx [mailto:ataraid-list-admin@xxxxxxxxxx] Im Auftrag von Lau Bech Lauritzen Gesendet: Samstag, 27. April 2002 03:01 An: ataraid-list@xxxxxxxxxx Betreff: Lost Interrupt, agian (on HPT370) Hey I really need help. I've been all over the internet looking for at solution to my problem. I've also seen a lot of people with the same problem, but nothing has helped yet. My problem is that i get a large amount of "hgx: lost interrupt" at start up on the disks on my HPT370 controller. Here's a little info: I'm running Debian with 2.4.19 pre6 kernel Tryed BIOS version 2.2 and 2.31 Tryed 2x60GB IBM 60GXP Tryed 2x60GB Mator Using High Points own 1.3 driver (hpt37x2.o) hpt37x2.o is in /lib/modules/2.4.19-pre6/ The module has also been added to /etc/modules [/] lsmod Module Size Used by Tainted: P NVdriver 941728 10 (autoclean) hpt37x2 57248 0 Everything works fine (the array has been parted), but mig boot time is about 5 min. and that's quite a draw back! Please help... -Lau PS: here's the dmesg VP_IDE: IDE controller on PCI bus 00 dev 21 VP_IDE: detected chipset, but driver not compiled in! VP_IDE: chipset revision 16 VP_IDE: not 100% native mode: will probe irqs later ide1: BM-DMA at 0xd800-0xd807, BIOS settings: hdc:DMA, hdd:DMA ide2: BM-DMA at 0xd808-0xd80f, BIOS settings: hde:pio, hdf:pio HPT372: IDE controller on PCI bus 00 dev 50 HPT372: detected chipset, but driver not compiled in! PCI: Found IRQ 9 for device 00:0a.0 HPT372: chipset revision 5 HPT372: not 100% native mode: will probe irqs later ide3: BM-DMA at 0x9000-0x9007, BIOS settings: hdg:pio, hdh:pio ide4: BM-DMA at 0x9008-0x900f, BIOS settings: hdi:pio, hdj:pio PDC20265: IDE controller on PCI bus 00 dev 88 PCI: Found IRQ 10 for device 00:11.0 PCI: Sharing IRQ 10 with 00:0b.0 PDC20265: chipset revision 2 PDC20265: not 100% native mode: will probe irqs later PDC20265: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode. ide0: BM-DMA at 0x6400-0x6407, BIOS settings: hda:pio, hdb:pio ide5: BM-DMA at 0x6408-0x640f, BIOS settings: hdk:pio, hdl:DMA hda: IC35L060AVER07-0, ATA DISK drive hdc: ASUS CD-S400/A, ATAPI CD/DVD-ROM drive hdd: PLEXTOR CD-R PX-W1210A, ATAPI CD/DVD-ROM drive hdg: MAXTOR 6L060J3, ATA DISK drive hdi: MAXTOR 6L060J3, ATA DISK drive hdk: IC35L040AVER07-0, ATA DISK drive hdl: IC35L040AVER07-0, ATA DISK drive ide0 at 0x7800-0x7807,0x7402 on irq 10 ide1 at 0x1f0-0x1f7,0x3f6 on irq 14 ide3 at 0xa400-0xa407,0xa002 on irq 9 ide4 at 0x9800-0x9807,0x9402 on irq 9 ide5 at 0x7000-0x7007,0x6802 on irq 10 hda: 120103200 sectors (61493 MB) w/1916KiB Cache, CHS=119150/16/63, UDMA(100) hdg: lost interrupt hdg: lost interrupt hdg: lost interrupt hdg: 117266688 sectors (60041 MB) w/1819KiB Cache, CHS=116336/16/63 hdg: lost interrupt hdg: lost interrupt hdi: lost interrupt hdi: lost interrupt hdi: lost interrupt hdi: 117266688 sectors (60041 MB) w/1819KiB Cache, CHS=116336/16/63 hdi: lost interrupt hdi: lost interrupt hdk: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, UDMA(100) hdl: 80418240 sectors (41174 MB) w/1916KiB Cache, CHS=79780/16/63, UDMA(100) hdc: ATAPI 40X CD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.12 Partition check: hda: [PTBL] [7476/255/63] hda1 hda2 hda3 hda4 < hda5 > hdg:hdg: lost interrupt [PTBL] [7299/255/63] hdg1 hdg2 hdg3 <hdg: lost interrupt > hdi:hdi: lost interrupt unknown partition table hdk: [PTBL] [5005/255/63] hdk1 < hdk5 > hdl: [PTBL] [5005/255/63] hdl1 < hdl5 > _______________________________________________ Ataraid-list@xxxxxxxxxx https://listman.redhat.com/mailman/listinfo/ataraid-list
