Lots of the onboard Promise and Highpoint controllers can be jumpered to be just an Ultra 100 Controller. I just do this and then use software RAID 1, and it works good and fast. I have done this on a few Asus A7V-133 based boxes with good success. For real FastTraks, I have heard that you can install one drive, boot and create an array, then remove it and do the same with the 2nd drive. Then install both, reboot, and do the RH Installation, and use SW RAID 1, and all will install well. I could probably dig up the exact posting describing this procedure. ----- Original Message ----- From: "Warren Togami" <warren@xxxxxxxxxx> To: <ataraid-list@xxxxxxxxxx> Sent: Sunday, March 24, 2002 7:29 AM Subject: Re: Serviceable RAID-1? > ----- Original Message ----- > From: "Arjan van de Ven" <arjanv@xxxxxxxxxx> > To: <ataraid-list@xxxxxxxxxx> > Sent: Tuesday, March 12, 2002 11:22 AM > Subject: Re: Serviceable RAID-1? > > > > > > The driver is included in the Red Hat kernels, > > just the installer doesn't work with it ;( > > > > Arjan, > > Is there any chance that the new Red Hat distrbution will be able to install > directly onto ATARAID? I have a dozen new prospective Linux users > complaining every week at the AMDMB Linux forum about not being able to > install onto FastTrak or Highpoint, and it would really bad nice if a > mainstream distribution could install easily for these users. People that > use this (crappy) controller are the vast majority of our users and we're > saddened when most of them give up in anger over this issue. =( > > How is the stability of RAID 1 in the latest driver? > > Thanks, > Warren Togami > warren@xxxxxxxxxx > > > > > _______________________________________________ > > Ataraid-list@xxxxxxxxxx > https://listman.redhat.com/mailman/listinfo/ataraid-list
