Using RH7.2 with all updates installed (including kernel 2.4.9).
Once upon a time I had this working. I now have linux on the onboard controller. I downloaded the ataraid tarball and ran make. No errors produced.
I insmod the ataraid module just fine, but the pdcraid module gives a seg fault. lsmod says pdcraid.o is initializing and rmmod is refused. I dont know what else to say. rebooting the server is the only way to remove the pdcraid module.
If I set my bios to boot SCSI, windows boots without a problem (striped array over 3 drives). This just verifies that my card indeed works and the filesystem is intact. I have used linux on this before so what is it? And now, an excerpt from dmesg:
**************
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz PCI bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c586b (rev 47) IDE UDMA33 controller on pci00:07.1
ide0: BM-DMA at 0xb000-0xb007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xb008-0xb00f, BIOS settings: hdc:DMA, hdd:pio
PDC20267: IDE controller on PCI bus 00 dev 50
PCI: Found IRQ 11 for device 00:0a.0
IRQ routing conflict for 00:0a.0, have irq 9, want irq 11
PDC20267: chipset revision 2
PDC20267: not 100% native mode: will probe irqs later
PDC20267: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
PDC20267: neither IDE port enabled (BIOS)
**************
Perhaps if I didnt have the irq error, all would be fine. Any clues on this one? Also, anyone know how to force the removal of a module?
-Mike Tharp
