Mathew, Following the comments below for two different points, libss7 will not load and in the /var/log/asterisk/messages file I get the message: Error[31611] chan_zap.c: Unspecified edfaultdpc! if I put it back with the sigchan like in the original zapata.conf it works. So it would appear intermixing the sigchan in the adjpointcode selection does not work. anyway.. Thanks Tom Chandler ----- Original Message ----- From: "Matthew Fredrickson" <creslin@xxxxxxxxxx> To: <asterisk-ss7 at lists.digium.com> Sent: Saturday, June 14, 2008 1:25 PM Subject: Re: libss7 - stp point codes > Tom Chandler wrote: >> on going testing: Question: >> >> In an ANSI setup, I have two A-Links. One to each of the mated STP's. >> >> in the zapata.conf, the adjpointcode (if I read it right) is for the STP >> point code. >> I have a different point code for each STP. Can you or How would you >> load >> both of these point codes into the configuration file. > > It's kind of a non intuitive interface for doing so, but this is how it > is done: > > adjpointcode=1-1-1 > sigchan=24 ; or whatever the first link is > adjpointcode=1-1-2 > sigchan=48 ; or whatever the second link is > > -- > Matthew Fredrickson > Software/Firmware Engineer > Digium, Inc. > > _______________________________________________ > --Bandwidth and Colocation Provided by http://www.api-digital.com-- > > asterisk-ss7 mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-ss7
|