On 05.06.21 20:04, Roland Pfeifer via arch-general wrote:
On 05.06.21 18:58, das via arch-general wrote:
On Sat, Jun 5, 2021 at 8:53 PM Roland Pfeifer via arch-general <
arch-general@xxxxxxxxxxxxxxxxxxx> wrote:
Is your camera setup as "Mass storage" under "Setup menu", "USB"?
At least my older camera works fine with this setting under
(Arch)-Linux.
Here are the dmsg i get:
usb 1-1.1: new high-speed USB device number 7 using xhci_hcd
usb 1-1.1: New USB device found, idVendor=04b0, idProduct=0419,
bcdDevice= 1.11
usb 1-1.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-1.1: Product: NIKON DSC D300
usb 1-1.1: Manufacturer: NIKON
usb 1-1.1: SerialNumber: xxxxxxxxxxxx
usb-storage 1-1.1:1.0: USB Mass Storage device detected
scsi host0: usb-storage 1-1.1:1.0
Dear Friend
Though 'lsusb' and 'usb-devices' are showing it, the system is not
showing
it at all. And obviously it is not getting mounted like a pen-drive or a
mass-storage.
One thing is after a kernel update modules may not get loaded. So you
may need a restart so usb-devices might get mounted.
Is a normal pen-drive working?
simpler to read the difference from "usb-devices":
Mass-storage Usb Mode:
T: Bus=01 Lev=02 Prnt=02 Port=00 Cnt=01 Dev#= 10 Spd=480 MxCh= 0
D: Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=04b0 ProdID=0419 Rev=01.11
S: Manufacturer=NIKON
S: Product=NIKON DSC D300
S: SerialNumber=000004176493
C: #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr=2mA
I: If#=0x0 Alt= 0 #EPs= 2 Cls=08(stor.) Sub=06 Prot=50 Driver=usb-storage
---------------------------------------------------------
Ptp-Mode Usb Mode:
T: Bus=01 Lev=02 Prnt=02 Port=00 Cnt=01 Dev#= 11 Spd=480 MxCh= 0
D: Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=04b0 ProdID=041a Rev=01.11
S: Manufacturer=NIKON
S: Product=NIKON DSC D300
S: SerialNumber=000004176493
C: #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr=2mA
I: If#=0x0 Alt= 0 #EPs= 3 Cls=06(still) Sub=01 Prot=01 Driver=(none)
