Hi Rob,
On Sat, 17 Nov 2018 at 16:51, Rob Herring <robh@xxxxxxxxxx> wrote:
>
> On Wed, Nov 14, 2018 at 01:16:42PM +0100, Clément Péron wrote:
> > Document the bindings for AK4118 S/PDIF transceiver
> >
> > Signed-off-by: Clément Péron <peron.clem@xxxxxxxxx>
> > ---
> > .../devicetree/bindings/sound/ak4118.txt | 22 +++++++++++++++++++
> > 1 file changed, 22 insertions(+)
> > create mode 100644 Documentation/devicetree/bindings/sound/ak4118.txt
> >
> > diff --git a/Documentation/devicetree/bindings/sound/ak4118.txt b/Documentation/devicetree/bindings/sound/ak4118.txt
> > new file mode 100644
> > index 000000000000..6e11a2f7404c
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/sound/ak4118.txt
> > @@ -0,0 +1,22 @@
> > +AK4118 S/PDIF transceiver
> > +
> > +This device supports I2C mode.
> > +
> > +Required properties:
> > +
> > +- compatible : "asahi-kasei,ak4118"
> > +- reg : The I2C address of the device for I2C
> > +- reset-gpios: A GPIO specifier for the reset pin
> > +- irq-gpios: A GPIO specifier for the IRQ pin
>
> This should use 'interrupts' instead.
Yes, this will also simplify the driver.
>
> > +
> > +Example:
> > +
> > +&i2c {
> > + ak4118: ak4118@13 {
>
> spdif@13 ? Node names should be based on the class of device, but
> there's not really one defined for this.
Ok I will use spdif.
Thanks for the comments,
Clement
>
> > + #sound-dai-cells = <0>;
> > + compatible = "asahi-kasei,ak4118";
> > + reg = <0x13>;
> > + reset-gpios = <&gpio 0 GPIO_ACTIVE_LOW>
> > + irq-gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
> > + };
> > +};
> > --
> > 2.19.1
> >
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
