On 03/30/16 09:21, Takashi Iwai wrote: > On Tue, 29 Mar 2016 19:23:12 +0200, > Russell King - ARM Linux wrote: >> >> On Tue, Mar 29, 2016 at 10:54:08AM +0200, Takashi Iwai wrote: >>> On Thu, 17 Mar 2016 13:22:29 +0100, >>> Jyri Sarha wrote: >>>> >>>> Add IEC958 channel status helper that gets the audio properties from >>>> snd_pcm_hw_params instead of snd_pcm_runtime. This is needed to >>>> produce the channel status bits already in audio stream configuration >>>> phase. >>>> >>>> Signed-off-by: Jyri Sarha <jsarha@xxxxxx> >>> >>> This patch looks almost good to me, but... >>> >>>> @@ -71,6 +59,7 @@ int snd_pcm_create_iec958_consumer(struct snd_pcm_runtime *runtime, u8 *cs, >>>> IEC958_AES4_CON_MAX_WORDLEN_24; >>>> break; >>>> case 24: >>>> + case 32: /* Assume 24-bit width for 32-bit samples. */ >>>> ws = IEC958_AES4_CON_WORDLEN_24_20 | >>>> IEC958_AES4_CON_MAX_WORDLEN_24; >>>> break; >>> >>> ... this change is silently slipped in. It should be mentioned in the >>> changelog, or split to another patch, as this is basically an >>> orthogonal change. >> >> Does it even make sense - AES doesn't have support for 32-bit samples, >> it can only ever truncate them down to 24-bit. > > Well, using SNDRV_PCM_FORMAT_S32_* for 24 bit samples is seen often on > real devices, mostly on PCI ones. So, adding the value 32 check there > itself is valid, I suppose. It's rather due to a bad design in the > current API. > That also happens on SoC environment i2s interfaces for various reasons. For instance if the i2s bit-clock for sample-rate * 24 * 2 is not available, but sample-rate * 32 * 2 is. > The actual bits should be specified hw_params.msbits field, instead. > But, not all drivers set this properly, unfortunately. > How about allowing the 32-bit format only if hw_params.msbits is set to 24 bits? I can set the hw_params.msbits to 24 in ASoC hdmi-codec's hw_params, can't I? I could also fake the whole hw_params struct that I pass to snd_pcm_create_iec958_consumer_hw_params(), but would that make sense? What ever the approach, I can of course split the 32 bit support into a separate subsequent patch, but for instance Beaglebone-black 48kHz 24-bit HDMI audio needs 32 bit format on i2s bus because of the available i2s bit-clocks. Best regards, Jyri _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
