Am Donnerstag, 14. Oktober 2010, 14:33:22 schrieb Daniel Mack: > On Thu, Oct 14, 2010 at 02:30:43PM +0200, Julian Scheel wrote: > > Am Donnerstag, 14. Oktober 2010, 14:06:41 schrieb Daniel Mack: > > > Yes, that looks suspicious, especially because it doesn't only affect > > > the lower bits. What do you need this sample rate converter for, > > > anyway? Can't you feed your signals directly to the DAC? FMT0 and FMT1 > > > should both be set to 0. > > > > You mean OFMT0 and OFMT1? Imho they should be 1,0 for I2S. Or did you > > refer to the DAC? In that case FMT0 and FMT1 both are set to 0. > > Jup, I was talking about the DAC. I have the SRC in there to be able to always feed that DAC with 192kHz, as it performs best in that mode and allows usage of a slow roll-off filter then. Anyway, I tried to directly feed the DAC module as well, but it does not produce any output so far... Not sure what's wrong there. As the dac is a current output dac, I am not sure whether it really does not output any signal, or if the current->voltage conversion does not work. Julian _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
