Hi Mark Sorry for the silly question but I have tried to route the gpio to the irq line on wm9713 without success. Can you comment the below code? Michael Trimarchi wrote: > Hi all, > > I'm trying to rise an irq using irq2 of the wm9713 so I have configured > the codec like this: > > #define GPIO2 (1 << 2) > #define GPIO6 (1 << 6) > > /* Enable Interrupt Output enable on GPIO02 */ > reg = codec->read(codec, AC97_MISC_AFE); > codec->write(codec, AC97_MISC_AFE, reg & ~GPIO02); > > reg = codec->read(codec, AC97_GPIO_CFG); > codec->write(codec, AC97_GPIO_CFG, reg & ~GPIO02); > > reg = codec->read(codec, AC97_GPIO_STICKY); > codec->write(codec, AC97_GPIO_STICKY, reg | GPIO06); > > reg = codec->read(codec, AC97_GPIO_WAKEUP); > codec->write(codec, AC97_GPIO_WAKEUP, reg | GPIO06); > > > Then create a soc-jack on a gpio that is wired with the gpio6 > of the codec. > > I don't received any interrupt > > Michael Trimarchi > _______________________________________________ > Alsa-devel mailing list > Alsa-devel@xxxxxxxxxxxxxxxx > http://mailman.alsa-project.org/mailman/listinfo/alsa-devel > > Regards Michael _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
