> > This patch adds jsl_rt5682_rt1015p which supports the RT5682 headset > > codec and ALC1015Q-VB speaker amplifier combination on JasperLake > > platform. > > > > This driver also supports ALC1015Q-CG if running in auto-mode. > > Following table shows the audio interface support of the two > > amplifiers. > > > > | ALC1015Q-CG | ALC1015Q-VB > > ===================================== > > I2C | Yes | No > > Auto-mode | 48K, 64fs | 16k, 32fs > > | 48k, 32fs > > | 48k, 64fs > > > > Signed-off-by: Brent Lu <brent.lu@xxxxxxxxx> > > The code is looks fine, but Jack Yu added a separate patch that makes > RTL1019 equivalent to RTL1015, so should this patch also handle the > RTL1019 case? > For rt1019 non-i2c mode (auto mode), it uses the sdb pin to enable amp, the same as rt1015 non-i2c mode, therefore we propose rt1019(auto mode) to use rt1015p instead of adding a new driver for it.
