On Thursday 19 July 2007 15:50:19 Takashi Iwai wrote:
> So, the primary problem is rather the 6stack-dig preset doesn't match
> with your device. The SPDIF problem seems independent, though, but
> we'd better to fix the stuff first.
>
> With auto model, do you get louder output from the analog out?
Just tested it and as far as I can tell, only spdif seems a lot louder, analog
output is equal to 6stack-dig.
Reminds me what also a bit strange: the PCM mixer control only appears after I
have played back something.
On detail: - unload alsa, rm asound.state, load alsa, alsamixer (no pcm vol)
- play back something, alsamixer (pcm volume is there)
>From there on, it'll always be visible, even after restarts. I also do not
have any channel configuration control (2/4/6 channels). It's just not there.
No matter if I use auto or 6stack-dig.
> The first thing to do is to check which pin widget corresponds to the
> real I/O jacks. It's a guess work and trial-and-error.
Sounds a lot like digging into patch_analog.c (a long change/recompile/test
cycle) or is there a way to figure this stuff out during runtime...? Could
you please elobrate on what I should do? Thanks.
Best regards,
Matthias Dahl
_______________________________________________
Alsa-devel mailing list
Alsa-devel@xxxxxxxxxxxxxxxx
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
