Re: [PATCH v2 0/2] soundwire: set frame shape and divider based on actual clk

[Pierre-Louis Bossart <pierre-louis.bossart@xxxxxxxxx>]

On 1/14/25 12:16 AM, Bard Liao wrote:
> Set frame shape and clock divider based on actual clock frequency. And
> with that change, we can support ckock change in Intel platforms.
> 
> v2:
>  - Mave the check before writing the divider registers
>  - Remove the 'freq' intermediate variable which is multiplied by two
>    after divided by two.
> 
> Bard Liao (2):
>   soundwire: cadence_master: set frame shape and divider based on actual
>     clk freq
>   Revert "soundwire: intel_auxdevice: start the bus at default
>     frequency"

This looks fine so 

Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@xxxxxxxxx>

but one additional question: what is the default start frequency? There is an expectation in SoundWire 1.2 that the bus starts at the slowest speed to allow for potential programming of PHY registers before bumping the speed to a higher rate. I don't recall what is typically listed in the _DSD properties, it'd be a mistake to start blindly with the first listed value if it happens to be the max rate.

>  drivers/soundwire/cadence_master.c  | 22 +++++++++++++++++++---
>  drivers/soundwire/intel_auxdevice.c | 21 ---------------------
>  2 files changed, 19 insertions(+), 24 deletions(-)
>