-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA256 Gao feng @ 12/12/2013 10:18 PM: > I saw there are two bridge br0 and virbr0 in your host. which > bridge the libvirt uses? what's result of #virsh net-list ? well i don't quite understand bridges and their function, i'm kinda just following directions. br0 replaced eth0 though in my interfaces file according to this guide[1] i followed to setup the bridge. i'm pretty sure virbr0 is what libvirt uses.... host$ cat /etc/network/interfaces auto lo iface lo inet loopback auto br0 iface br0 inet static address 67.180.246.122 netmask 255.255.255.248 gateway 67.180.246.121 dns-nameservers 67.180.241.11 67.180.241.12 bridge_ports eth0 bridge_fd 9 bridge_maxage 12 bridge_stp off host$ virsh net-list Name State Autostart - ----------------------------------------- default active yes host$ virsh net-dumpxml default <network> <name>default</name> <uuid>e6d3f97a-5870-8ee7-1d82-64b3434f138b</uuid> <forward mode='nat'/> <bridge name='virbr0' stp='on' delay='0' /> <ip address='192.168.122.1' netmask='255.255.255.0'> <dhcp> <range start='192.168.122.2' end='192.168.122.254' /> </dhcp> </ip> </network> $ 1. https://help.ubuntu.com/12.04/serverguide/network-configuration.html#bridging -----BEGIN PGP SIGNATURE----- iEYEAREIAAYFAlKrx58ACgkQXhfCJNu98qDHhwCguJBus/7kZj+5R2EAYSzSENg8 SFwAoLVCxi6jJQBaUhMl4Ter+Jnvq/rI =4wm8 -----END PGP SIGNATURE----- _______________________________________________ libvirt-users mailing list libvirt-users@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvirt-users