On 09/17/2012 10:40 AM, Peter Krempa wrote: > On 09/17/12 16:28, Laine Stump wrote: >> On 09/17/2012 05:02 AM, Peter Krempa wrote: >>> Some combinations of filtering flags produce no result. This patch >>> tries >>> to clarify this. >>> >>> Also fix unintentional double space. >>> --- >>> tools/virsh.pod | 11 ++++++----- >>> 1 file changed, 6 insertions(+), 5 deletions(-) >>> >>> diff --git a/tools/virsh.pod b/tools/virsh.pod >>> index c6f205a..2efb277 100644 >>> --- a/tools/virsh.pod >>> +++ b/tools/virsh.pod >>> @@ -395,10 +395,11 @@ into s3 state. >>> Normally only active domains are listed. To list inactive domains >>> specify >>> I<--inactive> or I<--all> to list both active and inactive domains. >>> >>> -To filter the list of domains present on the hypervisor you may >>> specify one or >>> -more of filtering flags supported by the B<list> command. These >>> flags are >>> -grouped by function. Specifying one or more flags from a group >>> enables the >>> -filter group. Supported filtering flags and groups: >>> +To further filter the list of domains you may specify one or more >>> of filtering >> >> >> While you're here: s/more of filtering/more of the filtering/ >> >> >>> +flags supported by the B<list> command. These flags are grouped by >>> function. >>> +Specifying one or more flags from a group enables the filter group. >>> Note that >>> +some combinations of flags may yield no results. Supported >>> filtering flags and >>> +groups: >>> >>> =over 4 >>> >> >> ACK with that one small addition. >> > > Bah, I just pushed it :(. I'll fix that in another patch. Not a big deal - it's just one word, and it was there already :-) -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list