On 09/17/2012 05:02 AM, Peter Krempa wrote: > Some combinations of filtering flags produce no result. This patch tries > to clarify this. > > Also fix unintentional double space. > --- > tools/virsh.pod | 11 ++++++----- > 1 file changed, 6 insertions(+), 5 deletions(-) > > diff --git a/tools/virsh.pod b/tools/virsh.pod > index c6f205a..2efb277 100644 > --- a/tools/virsh.pod > +++ b/tools/virsh.pod > @@ -395,10 +395,11 @@ into s3 state. > Normally only active domains are listed. To list inactive domains specify > I<--inactive> or I<--all> to list both active and inactive domains. > > -To filter the list of domains present on the hypervisor you may specify one or > -more of filtering flags supported by the B<list> command. These flags are > -grouped by function. Specifying one or more flags from a group enables the > -filter group. Supported filtering flags and groups: > +To further filter the list of domains you may specify one or more of filtering While you're here: s/more of filtering/more of the filtering/ > +flags supported by the B<list> command. These flags are grouped by function. > +Specifying one or more flags from a group enables the filter group. Note that > +some combinations of flags may yield no results. Supported filtering flags and > +groups: > > =over 4 > > @@ -435,7 +436,7 @@ domains without a snapshot I<--without-snapshot>. > When talking to older servers, this command is forced to use a series of API > calls with an inherent race, where a domain might not be listed or might appear > more than once if it changed state between calls while the list was being > -collected. Newer servers do not have this problem. > +collected. Newer servers do not have this problem. > > If I<--managed-save> is specified, then domains that have managed save state > (only possible if they are in the B<shut off> state, so you need to specify ACK with that one small addition. -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list