On 11/18/2009 09:28 AM, Thomas Treutner wrote: > On Wednesday 18 November 2009 14:05:03 Bryan Kearney wrote: >> thanks.. I am in the code right now.. what would have been better in the >> javadoc for you? I will put it in. > > ... > "If uri is NULL, then libvirt will try to find the best method. Uri may > specify the hostname or IP address of the destination host as seen from > the source, or uri may be a URI giving transport, hostname, user, port, > etc. in the usual form. Uri should only be specified if you want to migrate > over a specific interface on the remote host. For Qemu/KVM, the uri should be > of the form "tcp://hostname[:port]". This does not require TCP auth to be > setup between the connections, since migrate uses a straight TCP connection > (unless using the PEER2PEER flag, in which case URI should be a full fledged > libvirt URI). Refer also to driver documentation for the particular > URIs supported." > ... > > @Cole: I've merged your comment - could you please (N)ACK that? I assume > the "tcp://.." form is a special case for Qemu/KVM, as with Xen, an IP was > enough. > Sounds good to me. - Cole -- Libvir-list mailing list Libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list