On Wednesday 18 November 2009 14:05:03 Bryan Kearney wrote: > thanks.. I am in the code right now.. what would have been better in the > javadoc for you? I will put it in. ... "If uri is NULL, then libvirt will try to find the best method. Uri may specify the hostname or IP address of the destination host as seen from the source, or uri may be a URI giving transport, hostname, user, port, etc. in the usual form. Uri should only be specified if you want to migrate over a specific interface on the remote host. For Qemu/KVM, the uri should be of the form "tcp://hostname[:port]". This does not require TCP auth to be setup between the connections, since migrate uses a straight TCP connection (unless using the PEER2PEER flag, in which case URI should be a full fledged libvirt URI). Refer also to driver documentation for the particular URIs supported." ... @Cole: I've merged your comment - could you please (N)ACK that? I assume the "tcp://.." form is a special case for Qemu/KVM, as with Xen, an IP was enough. kr tom -- Libvir-list mailing list Libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list