According to xm.config manual, HVM pae|apic|acpi feature default is 1 (enabled). But in conversion from xm config to libvirt xml, if xm config doesn't contain pae|apic|acpi, it sets default value to 0, this causes some problems in HVM guest. Update parser codes to set HVM pae|apic|acpi default value to 1 to match xm config convension. Add tests data to test it. Chunyan Liu (2): xenconfig: set HVM pae/apic/acpi/ default to 1 Add tests to xmconfigtest src/xenconfig/xen_common.c | 6 +-- .../xmconfigdata/test-fullvirt-default-feature.cfg | 23 +++++++++++ .../test-fullvirt-default-feature.cfg.out | 26 ++++++++++++ .../xmconfigdata/test-fullvirt-default-feature.xml | 48 ++++++++++++++++++++++ tests/xmconfigtest.c | 9 +++- 5 files changed, 108 insertions(+), 4 deletions(-) create mode 100644 tests/xmconfigdata/test-fullvirt-default-feature.cfg create mode 100644 tests/xmconfigdata/test-fullvirt-default-feature.cfg.out create mode 100644 tests/xmconfigdata/test-fullvirt-default-feature.xml -- 1.8.4.5 -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list