|
Will this server get a dhcp address if you boot from the
boot.iso (or disk 1 with askmethod) and select http, ftp or nfs as your install
path?
If so, you are probably running into a switch timing issue
that I have to deal with every day. Try adding an ethtool option to the
end of your command line:
if 100MB Full Duplex:
ksdevice=eth0 eth0_ethtool="autoneg=off speed=100
duplex=full"
If 1000MB Full:
ksdevice=eth0 eth0_ethtool="autoneg=on speed=1000
duplex=full"
Chip From: kickstart-list-bounces@xxxxxxxxxx [mailto:kickstart-list-bounces@xxxxxxxxxx] On Behalf Of Elizabeth.Brosch@xxxxxxxxxxx Sent: Friday, October 07, 2005 12:31 PM To: kickstart-list@xxxxxxxxxx Subject: Kickstart fails I have been trying to get kickstart
working but have had no success. Here are the last few lines of the
kickstart process before it dies: *getting kickstart
file *sending dhcp request through device
eth0 *waiting for
link * 5
seconds * running dhcp for
eth0 * pump told us: No DHCP reply
received * eth0 isn’t a wireless
adaptor I have checked every possible
configuration with regards to dhcp, pxe, tftp, but cannot find anything
wrong. Has anyone else seen this type of
behavior? Thanks in
advance. Liz
Brosch TSH System
Services office: (215) 386-0100
x1144 cell: (267)
784-9166 |
