On 3/4/20 5:19 PM, Tim via users wrote: > On Wed, 2020-03-04 at 12:30 +0700, Frederic Muller wrote: >> it's a PIXLINK LV-WR09 300Mbps Wireless-N Repeater/Router/AP > Looking at this: > http://pmod1b8a3.pic8.websiteonline.cn/upload/WR09QuickInstallationGuide.pdf > > It looks like it should support the mode you want. Try using it as an > access point. Can you follow their guide? Get back to us with how far > you can manage to get. > Oh yes it supports the mod that I want, except that I am failing to connect to the printer probably because of IP routing issues. I was in fact expecting the LAN port to connect to the same subnet as if it was a Wifi connection to the repeater. Apparently it doesn't work this way. AP mode cannot work as I would need to lay a cable between my router and the AP: then I'm better off setting up the cable directly to the printer... which I cannot do. So my question is how can I connect from 192.168.0.x subnet to 192.168.1.x subnet (or specific printer IP) knowing this connection doesn't go through my router/firewall (which is on 192.168.0.1). The repeater IP is currently dynamic (I can probably set it as fixed) and falls randomly between 100 to 190, which would be the gateway to access the printer. And that's where my routing knowledge tells me there is a problem. Thank you. Fred _______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx
