On 11/23/2011 12:23 PM, Jim wrote: > On 11/23/2011 09:34 AM, mike cloaked wrote: >> On Tue, Nov 22, 2011 at 12:17 PM, Jim<binarynut@xxxxxxxxxxx> wrote: >> >>>> I can't tell from the messages output you posted if your machine is >>>> x86_64 or not but I had a very very similar issue with a Samsung >>>> scx4500w when I installed f16. >>>> >>>> It turned out that the copy of the file "rastertosamsungspl" was a 32 >>>> bit version and I had installed a 64 bit system - worth checking ? >>>> >>>> Also I notice that the name of your file is "rastertosamsungsplc" >>>> whereas it should be "rastertosamsungspl" i.e. you have an additional >>>> letter "c" at the end of the filename - if your file is really ending >>>> in a "c" then check whether you have the correct 32 or 64 bit file - >>>> if not then make sure that where you defined the file in the printer >>>> setup is correct - if not then redefine it with the correct filename. >>> I have a 32 bit box, >>> How do I determine wether the rastertosamungsplc is 32 or 64 bit? >>> In usr/lib/cups/filter/ there is a rastertosamsungsplc and a >>> rastertosamsungspl . >>> This is the same driver that I used Fedora 14 and 15 . >> OK - the answer as to which of 32 or 64 bit is where you got the file >> from? Presumably it is from the unified driver set from Samsung - in >> which case that will have difference directories for the 32bit and 64 >> bit file sets - one thing you can do is go back there and check the >> total file size - the 32 and 64 bit raster files are different sizes - >> which does yours match? >> >> Secondly you did not answer the question about using the correct name >> for the file when you defined the printer in Fedora - unless you >> changed the name of the actual file then the fail message indicated >> that you had the wrong filename - if course if you define it and point >> to a non-existent file then it is bound to fail! Check that again and >> see if that is the source of the problem. >> >> > THe unifiedLinuxDriver is the one I,m using ,it is the SAME driver > that I have installed on 32 bit boxes in Fedora 14 an 15 for this > CLX3175FN printer and now a 32 bit box in Fedora 16. > > The only thing I put into the setup was: > > URL: lpd://192.168.000.005 (this is the IP in the Router for > this printer, the same IP used on F14, F15) > > The rest was done in the setup. > > THanks Mike for your help on this problem. Mike I downloaded new Unified drivers from Samsung and installed and still get the same error message. The driver that is recommend during the install, and only driver available is Samsung CLX-3170 Series (SPL-C) Which I think explains the rastertosamsungsplc -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
