On 11/23/2011 11:50 AM, Jim wrote: > On 11/23/2011 12:31 PM, Kevin Martin wrote: >> On 11/23/2011 11:23 AM, Jim wrote: >>> On 11/23/2011 09:34 AM, mike cloaked wrote: >>>> On Tue, Nov 22, 2011 at 12:17 PM, Jim<binarynut@xxxxxxxxxxx> wrote: >>>> >>>>>> I can't tell from the messages output you posted if your machine is >>>>>> x86_64 or not but I had a very very similar issue with a Samsung >>>>>> scx4500w when I installed f16. >>>>>> >>>>>> It turned out that the copy of the file "rastertosamsungspl" was a 32 >>>>>> bit version and I had installed a 64 bit system - worth checking ? >>>>>> >>>>>> Also I notice that the name of your file is "rastertosamsungsplc" >>>>>> whereas it should be "rastertosamsungspl" i.e. you have an additional >>>>>> letter "c" at the end of the filename - if your file is really ending >>>>>> in a "c" then check whether you have the correct 32 or 64 bit file - >>>>>> if not then make sure that where you defined the file in the printer >>>>>> setup is correct - if not then redefine it with the correct filename. >>>>> I have a 32 bit box, >>>>> How do I determine wether the rastertosamungsplc is 32 or 64 bit? >>>>> In usr/lib/cups/filter/ there is a rastertosamsungsplc and a >>>>> rastertosamsungspl . >>>>> This is the same driver that I used Fedora 14 and 15 . >>>> OK - the answer as to which of 32 or 64 bit is where you got the file >>>> from? Presumably it is from the unified driver set from Samsung - in >>>> which case that will have difference directories for the 32bit and 64 >>>> bit file sets - one thing you can do is go back there and check the >>>> total file size - the 32 and 64 bit raster files are different sizes - >>>> which does yours match? >>>> >>>> Secondly you did not answer the question about using the correct name >>>> for the file when you defined the printer in Fedora - unless you >>>> changed the name of the actual file then the fail message indicated >>>> that you had the wrong filename - if course if you define it and point >>>> to a non-existent file then it is bound to fail! Check that again and >>>> see if that is the source of the problem. >>>> >>>> >>> THe unifiedLinuxDriver is the one I,m using ,it is the SAME driver that >>> I have installed on 32 bit boxes in Fedora 14 an 15 for this CLX3175FN >>> printer and now a 32 bit box in Fedora 16. >>> >>> The only thing I put into the setup was: >>> >>> URL: lpd://192.168.000.005 (this is the IP in the Router for >>> this printer, the same IP used on F14, F15) >>> >>> The rest was done in the setup. >>> >>> THanks Mike for your help on this problem. >> Really? The ip you have in the router is 192.168.000.005, not 192.168.0.5? Correct me if I'm wrong but those two addresses don't >> equate do they? >> >> Kevin > THat is the way it is shown in the router, but if you Ping that IP it is > shown as 192.168.0.5, It is the way this Motorola Modem/Router > treats the IP. I wonder if you set the IP in the printer config to 192.168.0.5 if anything would change. Kevin -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
