On 09/28/2011 10:09:48 AM, Terry Polzin wrote: > On Wed, 2011-09-28 at 09:55 -0700, JD wrote: > > On 09/28/2011 09:37 AM, Geoffrey Leach wrote: > > > I'm unable to configure a printer, connected via usb, under > Fedora > 15. > > > > > > Fedora 14 Anaconda recognized and configured automatically. The > > > hardware configuration has not changed. The URI for the printer > > > generated by Anaconda was usb://HP/LaserJet%201300 > > > > > > Using this URI to configure the printer on Fedora 15 does not > work; the > > > test page job is queued, but not printed. Ditto using > usb://HP/LaserJet > > > > > > FWIW, here's the USB description for the port. The "Belk" is a > Belkin > > > parallel-to-usb adapter. Same as under Fedora 14. > > > > > > > > > T: Bus=02 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh= 0 > > > D: Ver= 1.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1 > > > P: Vendor=050d ProdID=0002 Rev=02.02 > > > S: Manufacturer=Belk USB Printing Support > > > S: Product=IEEE-1284 Controller > > > C: #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA > > > I: If#= 0 Alt= 2 #EPs= 3 Cls=ff(vend.) Sub=00 Prot=ff > Driver=uss720 > > > > > > I'd really appreciate some assistance. > > > > > > Thanks. > > Have you tried to connect the printer directly > > to the parallel port, without the belkin converter, > > and reboot? > > > > Belkin devices aren't necessarily known for their linux support. Hmmm .... the converter has been working with many previous versions of Fedora. Could it be that linux is not supporting the device now? Seems unlikely, though, as all the device is doing is converting between Parallel and USB. Could also be that its died, athough doing it between 14 and 15 seems unlikely. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
