On Wed, 2011-09-28 at 09:55 -0700, JD wrote: > On 09/28/2011 09:37 AM, Geoffrey Leach wrote: > > I'm unable to configure a printer, connected via usb, under Fedora 15. > > > > Fedora 14 Anaconda recognized and configured automatically. The > > hardware configuration has not changed. The URI for the printer > > generated by Anaconda was usb://HP/LaserJet%201300 > > > > Using this URI to configure the printer on Fedora 15 does not work; the > > test page job is queued, but not printed. Ditto using usb://HP/LaserJet > > > > FWIW, here's the USB description for the port. The "Belk" is a Belkin > > parallel-to-usb adapter. Same as under Fedora 14. > > > > > > T: Bus=02 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=12 MxCh= 0 > > D: Ver= 1.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1 > > P: Vendor=050d ProdID=0002 Rev=02.02 > > S: Manufacturer=Belk USB Printing Support > > S: Product=IEEE-1284 Controller > > C: #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA > > I: If#= 0 Alt= 2 #EPs= 3 Cls=ff(vend.) Sub=00 Prot=ff Driver=uss720 > > > > I'd really appreciate some assistance. > > > > Thanks. > Have you tried to connect the printer directly > to the parallel port, without the belkin converter, > and reboot? > Belkin devices aren't necessarily known for their linux support. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
