2011/8/22 Lázaro Morales <lazaro@xxxxxxxxxxxxxxxx>: > > After a fresh install of libvirt in a box with one physical interface > (eth0), I tried to set up a bridged network in br0: > > [ifcfg-eth0:] > > DEVICE=eth0 > HWADDR=48:5b:39:ba:f9:2a > NM_CONTROLLED=no > BRIDGE="br0" > ONBOOT=yes > NETMASK=255.255.255.0 > IPADDR=192.168.0.10 > GATEWAY=192.168.0.2 > DNS2=192.168.0.6 > TYPE=Ethernet > BOOTPROTO=none > DNS1=192.168.0.5 > IPV6INIT=no > USERCTL=no > > [ifcfg-br0] > > DEVICE=br0 > TYPE=Bridge > BOOTPROT="dhcp" > ONBOOT=yes > DELAY=0 > NM_CONTROLLED=no > BOOTPROTO=dhcp > IPV6INIT=no > USERCTL=no > > After that I get this: > > br0 Link encap:Ethernet HWaddr 48:5B:39:BA:F9:2A > inet addr:192.168.0.122 Bcast:192.168.0.255 Mask:255.255.255.0 > inet6 addr: fe80::4a5b:39ff:feba:f92a/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:398 errors:0 dropped:0 overruns:0 frame:0 > TX packets:156 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:36074 (35.2 KiB) TX bytes:23902 (23.3 KiB) > > eth0 Link encap:Ethernet HWaddr 48:5B:39:BA:F9:2A > inet6 addr: fe80::4a5b:39ff:feba:f92a/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:417 errors:0 dropped:0 overruns:0 frame:0 > TX packets:167 errors:0 dropped:0 overruns:0 carrier:2 > collisions:0 txqueuelen:1000 > RX bytes:43047 (42.0 KiB) TX bytes:24860 (24.2 KiB) > Interrupt:28 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > > virbr0 Link encap:Ethernet HWaddr 8E:37:DB:3B:46:3F > inet addr:192.168.122.1 Bcast:192.168.122.255 > Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > > And now I don't have an IP address in eth0, but I have one br0. eth0 won't and shouldn't have an IP address. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
