On Tue, 2010-06-08 at 16:36 -0700, Suvayu Ali wrote: > > To extract only a specific file: > > $ tar xf bobg.tar.gz the/file/you/want > > > > I think the OP's worry is not whether it can be done, but he wants to > avoid the time and CPU cycles involved in the gunzip step. Since he > has his entire home directory in the tarball, even extracting a single > file requires tar to decompress the entire tarball before it can > extract that one file. Without looking at the source code one can't be sure, but I'd be surprised if that were literally true. IOW I doubt that tar decompresses everything to a temp file and then searches for the target. It should only be necessary to decompress up to the position of the target file (recall that tar originally meant "tape archiver", i.e. it's very focussed on doing things in a single sequential pass). I assumed that was what the OP wanted to do, and I believe the solution offered achieves it. Furthermore, given that the Gzip compression algorithm is stream-based, there cannot by definition be any substantially more efficient way of doing it other than decompressing the stream up to the point of interest. The alternative archive method (compress each file and then tar up the result), would be somewhat easier to extract in this specific case, but at the cost of a poorer compression ratio. It's the old space/time tradeoff once again. poc -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
