Craig, On Sun, Mar 28, 2010 at 3:23 PM, Craig White <craigwhite@xxxxxxxxxxx> wrote: > On Sun, 2010-03-28 at 15:16 -0700, Darlene Wallach wrote: >> After I partition, format and label the Seagate FreeAgent Go 1T drive >> and I'm ready to mount it is this what I should use: >> >> mount -t fuseblk -o rw,nosuid, nodev,allow_other,blocksize=4096 >> /dev/sdb1 /media/<myLabel> >> >> Should I add - uhelper=hal to the mount? >> >> mount -t fuseblk -o rw,nosuid, >> nodev,uhelper=hal,allow_other,blocksize=4096 /dev/sdb1 >> /media/<myLabel> >> >> what about adding shortname=lower to the mount? >> >> mount -t fuseblk -o rw,nosuid, >> nodev,uhelper=hal,shortname=lower,allow_other,blocksize=4096 /dev/sdb1 >> /media/<myLabel> >> >> Thank you for your attention, consideration, and feedback. > ---- > What is it that you hope to accomplish by forcibly mounting this rather > than just allowing the natural mount occur when you plug it in? I am unmounting the drive then partitioning and formatting the drive for ext3. I thought I would have to mount it after that. > > Craig > Darlene Wallach -- equal justice under law -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
